Skip to content
Start building
Printed frame 4U 10" Draft frame

4U 3D printed homelab rack buildin a PrintableRacks R2

Our easy-build frame at desk size: patch panel, 2.5G switch, a ThinkCentre Tiny and power. It is built in the PrintableRacks R2, 4U tall and 230 mm deep, and passes every check in the builder.

Opening it swaps out the rack on screen; the builder keeps your previous rack so you can restore it. Change anything in the builder; the checks run as you go.

Key facts

  • This 4U 3D printed homelab rack build uses the PrintableRacks R2 at 4U and 230 mm deep, a first-draft frame nobody has printed yet.
  • It holds 5 parts and uses 4 of 4U.
  • Typical power draw adds up to 22 W and the parts weigh about 3 kg.
  • Printed parts take about 875 g of filament; bought parts with a known price add up to about $280.
  • Outside, the rack is about 262 mm wide, 230 mm deep and 224 mm tall.

Why the PrintableRacks R2?

Our easy one: two one-piece sides, two plates, eight screws. Print files exist; not yet printed. PrintableRacks R2 (our first draft, not printed or load-tested yet) is 230 mm deep here, so the deepest device, the Lenovo ThinkCentre Tiny (M720q / M920q) at 183 mm, fits with 47 mm to spare. At 4U the build uses 4U and leaves 0U free.

Specs, trade-offs and what else fits: PrintableRacks R2.

Where everything goes, top to bottom

Print 2

  • PrintableRacks R2 frame, 4U≈ 765 gPrintableRacks
  • 1U shelf≈ 110 gGeneric

Buy 4

As an Amazon Associate we earn from qualifying purchases. Amazon links go to the exact listing where we have checked one, otherwise to a search; check the model before you buy.

Filament is estimated; prices are typical US street prices and go out of date. The frame line is the whole frame at 4U.

What could you swap or add?

Each suggestion below was checked against this exact build: swap it in, or add it on its own shelf, and the builder still reports no problems.

Swap

  • Instead of the Lenovo ThinkCentre Tiny (M720q / M920q)HP EliteDesk 800 Mini (G4-G6), Dell OptiPlex Micro (7080 / 7090), ASUS NUC 14 Pro (slim), Mac mini (M1 / M2)

The rack is full at 4U; a taller frame would give you room.

Will the same gear fit another rack?

All builds · All 17 frames